Advertisement
Available languages
Available languages
TABLE LEG INSERTS (FIG. 1)
The router table includes two table leg inserts:
• Storage panel for convenient storage of accessories
• Cord Wrap Panel
The table leg inserts must be installed before attaching
the table top.
1. Place the table leg insert into the opening in the
table leg so that it is positioned at the very top of
the opening.
2. Press the insert in so that it is completely flush with
the leg.
3. Push the insert down as far as it will go to lock it
in place.
NOTE: The cord wrap panel has two tabs at the top
of the panel that lock under the table top. These tabs
help prevent the panel from coming unhooked when
wrapping or unwrapping the cord.
TOOLS REQUIRED (not included)
•
Phillips screwdriver
•
Small sized adjustable wrench
•
Tape with adhesive backing (optional)
ROUTER TABLE LEGS (FIG. 2)
1.
Insert eight 1/4-20x1-1/2" long carriage bolts (39)
through the router table top as shown in Fig. 2.
2.
Place a leg reinforcement over each set of
carriage bolts.
3.
Assemble the legs to the router table as shown in
the figure.
4.
Assemble a 9/32" ID x 5/8 OD" x 1/16" thick wash-
er (36) and a 1/4-20 "KEPS" nut (32) onto each of
the bolts.
5.
Securely tighten the fasteners.
NOTE: It may be easier to assemble the legs by
laying the router table on its front or back, or by using
adhesive tape over the carriage bolt heads to hold
them in place and turning the router table upside down.
Router Table Assembly
ASSEMBLING THE ROUTER TABLE
10
FIG. 1
CORD WRAP
PANEL
FIG. 2
1/4-20x1-1/2" CARRIAGE
BOLTS
LEG
REINFORCEMENTS
STORAGE
PANEL
9/32 x 5/8 x 1/16"
WASHER
1/4-20 KEPS NUT
LEG
Advertisement
