Mitsubishi Electric MXZ-SM72TAM-U1 Service Manual page 136

2. Enter the unit number.
• Press the TEMP
• Direct the wireless remote controller toward the receiver of the indoor unit and press the
By setting the unit number with the
Detect which unit is assigned to which number using this function. If unit number is set to AL, all the indoor units in
the same refrigerant system start performing fan operation simultaneously.
Notes:
• If a unit number that cannot be recognized by the unit is entered, 3 beeps of 0.4 seconds will be emitted.
Reenter the unit number.
• If the signal was not received by the sensor, no beep or a ˝double beep˝ will be emitted. Reenter the unit number.
3. Select a mode.
• Press the TEMP
• Direct the wireless remote controller toward the sensor of the indoor unit and press the
→ The sensor-operation indicator will blink and beeps will be emitted to indicate the current setting number.
Current setting number: 1 = 1 beep (1 second)
Notes:
• If a mode number that cannot be recognized by the unit is entered, 3 beeps of 0.4 seconds will be emitted.
Reenter the mode number.
• If the signal was not received by the sensor, no beep or a ˝double beep˝ will be emitted. Reenter the mode number.
4. Select the setting number.
• Press the TEMP
• Direct the wireless remote controller toward the receiver of the indoor unit and press the
→ The sensor-operation indicator will blink and beeps will be emitted to indicate the setting number.
Setting number: 1 = 1 beep (0.4 seconds each)
Notes:
• If a setting number that cannot be recognized by the unit is entered, the setting will turn back to the original setting.
• If the signal was not received by the sensor, no beep or a ˝double beep˝ will be emitted. Reenter the setting number.
5. Repeat steps 3 and 4 to make other function setting on the same unit.
6. Repeat steps 2 to 4 to change the unit and make function settings on it.
7. Complete the function settings
• Press
Note:
• Do not use the wireless remote controller for 30 seconds after completing the function setting.
13-5-3. PAR-SL101A-E
Operating instructions
1. Go to the function select mode.
• Press the
appears on the display and ˝00˝ blinks.
CHECK
• Press the
• Direct the wireless remote controller toward the receiver of the indoor unit and press the
2. Set the unit number.
• Press the
• Direct the wireless remote controller toward the receiver of the indoor unit and press the
OCH800A_136
button to enter the unit number.
min
button to set a mode.
2 = 2 beeps (1 second each)
3 = 3 beeps (1 second each)
button to select the setting number.
2 = 2 beeps (0.4 seconds each, repeated twice)
3 = 2 beeps (0.4 seconds each, repeated 3 times)
button.
button for 5 seconds. (Start this operation from the status of remote controller display turned off.)
button to enter ˝50˝.
button to set unit number A.
button, the specified indoor unit starts performing fan operation.
min
button.
h
button.
h
button.
button.
button.