Mitsubishi Electric MXZ-SM72TAM-U1 Service Manual page 129

Mode button (Changes operation mode)
Airflow button (Changes up/down airflow direction)
*1. This button is enabled or disabled depending on the model of the indoor unit.
Display
Operation mode
Cool
Fan
Heat
Temperature setting
The units of temperature
can be changed. For details,
refer to the Installation Manual.
Vane setting
Step 1 Step 2 Step 3 Step 4 Step 5 Swing Auto
13-2. Error information
Operating instructions
■ How to check the error information when an error occurs
When an error occurs, the following screen will appear. Check the error status, stop the operation, and consult your deal-
er.
1. Check the error information
Check code, error unit, refrigerant address, date and time of occurrence, model name, and serial number will appear.
The model name and serial number will appear only if the information has been registered.
• Press the F1 or F2 button to go to the next screen.
• Contact information (dealer's phone number) will appear if the information has been registered.
OCH800A_129
Set Temperature buttons
Timer ON button
Timer OFF button
Weekly timer ON/OFF button
*1
Set Time button (Sets the time)
Dry
Auto
(single set
point)
Auto
(dual set
point)
Transmission area
Remote controller display
OFF/ON button
Fan Speed button (Changes fan speed)
i-see button
*1
Menu button
SET/SEND button
CANCEL button
Up/Down button
Reset button
Not available
Appears when a non-supported
function is selected.
Battery replacement indicator
Appears when the remaining battery
power is low.
Fan speed setting
Auto
3D i-See sensor (Air distribution)
Default Direct Indirect
When Direct or In-
direct is selected,
the vane setting is
set to ˝Auto˝.