Baby Jogger eco city mini GT2 Assembly Instructions Manual page 17

47 To change belly bar angle, press and
hold the adjustment buttons on both
sides while raising or lowering the belly
bar to the desired position.
48 To remove belly bar, press and hold
the release button.
49 While holding the release button, pull
the belly bar out of the mount.
BABY JOGGER/GRACO CAR SEAT
ADAPTER
WARNING: When attaching car seat
adapter, the canopy zipper must be
zipped.
50 Recline the backrest of the stroller.
51 Make sure the elastic fabric near
the accessory mounting slots is not
covering the slots.
52 Insert Adapter Brackets into the
corresponding mounting brackets on
your stroller/pushchair. The Adapter
Brackets are secure when they click
into place.
NOTE: Left and right are determined
by standing in front of and facing the
stroller and each Adapter Bracket
is labeled with an L or an R for your
convenience.
53 Place car seat on the car seat adapter
brackets and press down firmly until it
clicks into place.
54 Lift up on the car seat to make sure it
is attached.
WARNING: Only attach the car seat in
a Rear-Facing position.
To remove car seat:
Follow the steps in your car seat' s
instruction manual to remove car seat
from adapters.
To remove adapters:
55 Push the release button on each
adapter and pull upward to remove.
WARNING: Remove car seat adapter
when folding and unfolding the stroller.
Scan for
compatibility
17
EN