Table of Contents
Advertisement
Connecting Player to Computer
To a desktop computer
SCSI board and SCSI cable *1 are required.
For further information, refer to your SCSI interface manual.
Panasonic recommends either an Adaptec AHA-1542C or Future Domain TMC-1670, etc.
The SCSI board must be "ASPI" compatible.
If your desktop computer has a PCMCIA card slot, you can connect the player to the
computer by using the supplied PC card and PCMCIA cable. Refer to 'To a notebook
computer" ( US3 P. 17).
Cautions:
*1 • Use a shielded SCSI cable of 1.5 m (4.9 ft.) or shorter.
• Plug half-pitch or full pitch end of SCSI cable into computer and the half-pitch end
into the player.
■
Daisy chain connection:
You can connect this player to other SCSI devices (up to seven devices). Make sure that
each SCSI device has different SCSI ID number.
For setting the SCSI ID number and terminator of this player, refer to "SCSI ID Number
and Terminator" ( ugr P. 34).
Host computer
Hard disk drive
CD-ROM Player
(Factory setting of SCSI ID
number is 5, and be sure the
terminator is set to ON)
Note:
• You can hear the computer sound by installing the Sound board.
18
Advertisement
Table of Contents
