Table of Contents
Advertisement
THE VRF-700 RF ADAPTOR is used to connect the camcorder to a TV receiver for tape playback or camera momtoring.
This can be performed in two ways : to the aerial input of the TV or to its AV mputs
if
so equipped.
the diagrams show either connection. Note the VRF-700 switch positions.
FOR TV's WITHOUT AUDIO/VIDEO INPUT TERMINALS
RF adaptor VRF-700
RF CHANNEL screw
Make connections as shown beiow. Connectmg your TV an;e''na(aeriai)
to the RF adaptor as shown is an optional convenience.
Switch camcorder power on. Confirm camera picture in the v.ewfinder.
On the TV, select a spare channel
Position
(or one designateo for VCR
use).
Use the TV tuning Controls to find the camera picture on the screen.
Preset or memorise this Position on the TV for future use
The RF CHANNEL screw on the VRF-700 is normally se: at a postion where
interference Problems are unlikely, but it can. if necessary. Pe adjusted
over a limited UHF ränge. If altered re-tune the TV to the new Position.
The l/G selector switch should be set to 'T' for UK TV rece .ers.
Advertisement
Table of Contents
