Safety Precautions - Kenwood DP-J1070 Instruction Manual

'\, Caution: Read this l y to ensure sate opergicip
DP-J1070/J695 {En]
Units are designed for operation as follows.
Be US Al. tained CARO soc soacascinsncecocsscenttlets nie vatvonvcon sca usVansiexiadio AC 120 V only Eetrope and UK, scccsiscccicsoessns cuvcecsncesscniesnrasennonseesonseis .- AE 238 V only
ABUSE ALIA cesccrsoscsscresoseerserecsersserscesoeenssseestenensentestertrenrererseneeermnens A 240 V only "OTOL COLUTEVIOS ccccccorccesacesecssessrecereereceee ACI 10- 120/220-240 VY switchable
* AC voltage selection
The AC voltage selector switch on the rear panel is set to the
voltage that prevails in the area to which the unitis shipped. Before
connecting the power cord to your AC outlet, make sure that the
setting position of this switch matches your tine voltage. If not, it
must be set to your voltage in accordance with the following
direction.
AC voltage selector switch
AC — : Meve switch lever to match your
aN Sen line voltage with a smail screw-
driver or other pointed tool.
Note:
Our warranty does not cover damage caused by excessive line
voltage due to improper setting of the AC voltage selector switch.
__Safety precautions _
ASEAN GAR) Chetan pyre ag FEMA anlalemitastl paras hahaa neeliierac a anes rae
WARNING: TO PREVENT FIRE OR ELECTRIC SHOCK, DO NOT EXPOSE THIS APPLIANCE TO RAIN OR
MOISTURE.
ear EE EOTHIC SHOCK BACK). NO USER-SERVICEABLE PARTS INSIDE, REFER SERVICING TO QUALIFIED SERVICE
DO NOT OPEN PERSONNEL.
THE LIGHTNING FLASH WITH ARROWHEAD SYMBOL, WITHIN AN EQUILATERAL TRIANGLE, IS INTENDED TO ALERT THE USER TO
THE PRESENCE OF UNINSULATED "DANGEROUS VOLTAGE" WITHIN THE PRODUCT'S ENCLOSURE THAT MAY BE OF SUFFICIENT
MAGNITUDE TO CONSTITUTE A RISK OF ELECTRIC SHOCK TO PERSONS.
THE EXCLAMATION POINT WITHIN AN EQUILATERAL TRIANGLE IS INTENDED TO ALERT THE USER TO THE PRESENCE OF
IMPORTANT OPERATING AND MAINTENANCE (SERVICING) INSTRUCTIONS IN THE LITERATURE ACCOMPANYING THE APPLIANCE.
The marking of products using lasers
(Except for some areas.)
CLASS 1 |
LASER PRODUCT |
The label is attached to the rear panel and says that the component
uses laser beams that have been classified as Class 1. |t means that
the unit is utilizing laser beams that are of a weaker class. There is
no danger of hazardous radiation outside the unit.