Table of Contents
Advertisement
2. Verify all connections: the DS3 LINK/ALARM LEDs on the front of the network
extender will pulse green to indicate the connections are established and
operational.
Single DS3 Connection
A single line connection can be established between a single port subscriber unit and
either a single port or dual port ETHX-DS3-x-LT provider unit. Likewise, a single line
connection can also be established between a single port provider unit and either a
single port or dual port ETHX-DS3-x-LT subscriber units.
Procedure
1. Plug two coax cables, one for transmit (Tx) and one for receive (Rx), into the DS3
BNC 75 ohm ports on the back of the network extender.
2. Verify the connection: the DS3 LINK/ALARM LED on the front of the network
extender will pulse green to indicate the connection is established and operational.
Connecting the Ethernet Lines
The 10/100BaseT Ethernet ports can auto-negotiate speed and duplex mode in
accordance with the remote equipment to which it is connected, or Ethernet speed and
duplex mode configurations can be configured using web management. (See Web
Interface on page 12.) For the best connection results, the remote devices (PCs, hubs,
or switches) should be set to auto-negotiate speed and duplex mode.
Procedure
1. Plug the Ethernet cable into one of the 10/100 ETHERNET ports on the back of
the network extender. A straight-through cable can be used for all applications.
2. Verify the connection: solid green illumination of the corresponding
10/100 ETHERNET Connection LINK/ACT (Link/Activity) LED on the front of the
network extender indicates a connection has been established. If the Ethernet
LINK/ACT LED is illuminated but not the Ethernet 100 LED, then a 10 Mbps
connection has been established. If the Ethernet LINK/ACT and 100 LEDs are
both illuminated, then a 100 Mbps connection has been established.
9
Advertisement
Table of Contents
