Zhone ETHX-DS3-1-LT Installation Instructions Manual page 13

Web Interface System Requirements
Web Browser – Required for running web management. Compatible web
browsers include, but are not limited to, Microsoft Internet Explorer (v4.0 or higher)
and Netscape Navigator (v4.0 or higher). web management is optimized for use
with Internet Explorer.
Use your browser's default settings when running web management. JavaScript
must be enabled.
Screen Resolution – 1024 x 768 pixels is the minimum resolution required for all
web management views to fit within the dimensions of most monitors and laptops.
Lower screen resolutions (such as 800 x 600 pixels) may cause web management
screens to exceed the width or height of the screen. To verify screen resolution on
a Windows system:
— Right click on your desktop
— Select Properties
— Click the Settings tab
— Adjust the Screen Resolution as needed
Configuring Your Windows PC to Communicate with Web Management
To communicate with web management, your PC's Ethernet interface must be on the
same subnet as the network extender. For example, to configure the IP address under
Windows XP:
Procedure
1. In the Windows task bar, click on the Start button, and then click on Control Panel.
2. Double-click on the Network Connections icon.
3. In the LAN or High-Speed Internet window, right-click on the icon corresponding to
your network interface card (NIC) and select Properties. (Often this icon is labeled
Local Area Connection.) The Local Area Connection dialog box is displayed with a
list of currently installed network items.
4. Ensure that the check box to the left of the item labeled Internet Protocol (TCP/IP)
is checked, and click on Properties.
5. Write down the current IP Address and Subnet Mask in the Internet Protocol
(TCP/IP) Properties dialog box. When you are done using web management, you
will need to reconfigure your PC with these values.
6. In the Internet Protocol (TCP/IP) Properties dialog box, click in the radio button
labeled "Use the following IP address" and type 192.168.254.x (where x is any
number between 3 and 250, inclusive) in the IP Address field.
7. Type 255.255.255.0 in the Subnet Mask field.
8. Click on OK twice to confirm your changes, and close the Control Panel.
9. Start your web browser. Type 192.168.254.252 (for a provider unit) or
13