Provider and Subscriber Unit Defaults
The following table highlights the differences between Provider and Subscriber units.
Table 1. Unit Defaults by Type
Feature
Default IP Address
Out-of-Band Management
In-band Management
Response to Broadcast ARP
Request by IP Address
Package Contents
Unpack and inspect the network extender. If there is any visible damage, do not
attempt to install or connect the device. Instead, please contact your local sales
representative, service representative, or distributor. Please refer to the Service and
Repair section of this manual for additional support and contact information.
Release Notes
Before installing your network extender, you should update to the latest firmware load
and review the associated release notes for your model. These are available for
download on the Service & Support page under the Downloads heading at the Zhone
website.
http://www.zhone.com/support/downloads/firmware/ETHX-22xx/
Product Documentation Online
Complete documentation for Zhone products is available at http://www.zhone.com/.
Select Service & Support, and then select Documentation.
http://www.zhone.com/support/manuals/
To order a paper copy of a Zhone document, or to speak with a sales representative,
please call (877) 946-6320 (i.e. 877-ZHONE20).
Provider Unit
192.168.254.252
Over Ethernet Ports
Over DS3 Ports
Unit answers
6
Subscriber Unit
192.168.254.251
Over DS3 Ports
Over Ethernet Ports
Unit does not answer on
DS3 ports; answers only to
ARP request on Ethernet
ports.