Logging Into The Cli - Zhone ETHX-2214-DS3 Installation Instructions Manual

Launching the Terminal Emulation Program
Launch a terminal emulation program on your PC and configure the program settings.
The terminal emulation software should be configured as follows (refer to your terminal
emulation program's user manual for further information).
Baud:
Data Bits:
Flow Control:
Parity:

Logging into the CLI

Once your terminal emulation program has been launched, device information is
displayed, followed by a request for username and password. You must log in as a
superuser in order to make configuration changes.
Username (case sensitive):
Password (case sensitive):
Using the CLI to Establish In-band Management
Option 1:
After you have logged in, enter a question mark (?) to list the available commands. CLI
Set commands are used to establish in-band management. For example:
set slot 1 ip_address 137.182.10.251
set slot 1 subnet_mask 255.255.255.0
set slot 1 default_gateway 137.182.10.10
The Subscriber unit in this example can now be managed with web management by
attaching a PC to one of the network extender's Ethernet ports or through the DS3
ports by opening the address 137.182.10.251 in a web browser.
Option 2:
After you have logged in, enter "H" for Help, to list the available commands. CLI
commands are used to establish in-band management. For example:
cd syscfg
cd mgtcfg
ipaddress 137.182.10.251
subnetmask 255.255.255.0
defaultgateway 137.182.10.10
submit
Note – It is necessary to type submit and hit enter for the settings to be enabled
9600 Port:
Stop Bits:
8
Transmit Delay:
none
none
superuser
Password
20
Com 1
1
n/a