Advertisement
For programming information:
For further installation information:
The WK-CONNECT is required for the following products:
WK-PIR, WLED30CV4, WLED75CV1,
Contents
1. What is the WK-CONNECT?
2. Installation of the WK-CONNECT
3. Terminating the WK-CONNECT
4. Troubleshooting the Wired Network
5. Appendix 1 - Wiring Examples
What is the WK-CONNECT?
The WK-CONNECT is used to connect certain products to the Rako Wired network via a
punchdown and RJ11. It also provides termination jumpers, which must be set
appropriately for the system to work correctly.
Installation of the WK-CONNECT
Step 1
Step 2
WK-CONNECT
Wired System Programming Guide
The Wired RAK Application Sheet
WLED150CV1
Prepare the WK-CONNECT for
connection by unscrewing and
removing the lid.
Punch down the CAT cable(s),
matching cable colours to match the
circuit board.
There can be up to two sets of cables
to punch down.
Version 2.1.2
Advertisement
