Factory Settings - ebm-papst A3G910-AV02-01 Operating Instructions Manual

A3G910-AV02-01
Fans installed upright
When routing the cable, make sure that the cable glands are located at
the bottom. The cables must always be routed downward.
Fig. 4: Cable routing for fans installed upright.

4.4 Factory settings

Factory settings made for the device by ebm-papst.
Mode parameter set 1 PWM control
Mode parameter set 2 PWM control
Fan/device address 01
Max. PWM / %
100
Min. PWM / % 5
Save set value to Yes
EEPROM
Set value requirement Analog (linear)
Direction of action Positive (heating)
parameter set 1
Direction of action Positive (heating)
parameter set 2
Item no. 50266-5-9970 · ENU · Change 260687 · Approved 2022-06-22 · Page 9 / 14
ebm-papst Mulfingen GmbH & Co. KG · Bachmühle 2 · D-74673 Mulfingen · Phone +49 (0) 7938 81-0 · Fax +49 (0) 7938 81-110 · info1@de.ebmpapst.com · www.ebmpapst.com
Operating instructions