Table of Contents
Advertisement
Adjusting the picture
The picture settings have been adjusted by the
factory under optimum signal reception
conditions, however conditions may not be the
same in your area. After turning on your
television, allow it to warm up for a few
minutes before making any adjustments.
CALL
P
OK
P
NOTE :
Should you wish to reset picture controls to
factory settings (MODE-1/MODE-2/MODE-3),
press
to select your preferable picture
contrast.
12
If the picture is not to your liking, make the following adjustments
using the remote control.
1
Press MENU on your remote
control. The on screen
display will appear.
2
Press P▲ or P▼ to select
picture menu.
Press OK to select adjustment
screens.
3
Press P▲ to view brightness, contrast, colour or sharpness
on screen displays. (Tint menu will be displayed when an
NTSC signal is input on SCART.)
Press
+/– to adjust the
levels.
• Pictures appear sharpest in
the daytime by increasing
the contrast. In the evening
(when surroundings are
darker) the sharpest picture
can be obtained by reducing
the contrast.
4
Press MENU twice to remove
the picture menu from the
screen.
• If you do not make an
adjustment within 1 minute
the menu will disappear.
PICTURE ADJUSTMENT :
Your preferable picture contrast can be selected by pressing
(Selectable Picture) button repeatedly.
PICTURE
MODE-M
(User's Settings)
ON/OFF TIMER
SETUP
PICTURE
EXT COLOUR AUTO
LANGUAGE
PANEL LOCK ON OFF
PRESS :
ON/OFF TIMER
SETUP
PICTURE
EXT COLOUR AUTO
LANGUAGE
PANEL LOCK ON OFF
PRESS :
BRIGHTNESS
PRESS : +/–/
PICTURE
PICTURE
MODE-1
MODE-2
/
/ OK / MENU
/
/ OK / MENU
32
/
/ MENU
ON
PICTURE
MODE-3
Advertisement
Table of Contents
