Paradyne COMSPHERE 3800 Series Quick Reference page 11

Configuration Option Procedures (continued)
AT Commands
Loading Factory Configurations
Use the AT&F y &W n command to load a factory configuration to either the Active (Saved),
Customer 1, or Customer 2 configuration area.
Type: AT&F y &W n
where: y is one of the following factory configurations:
0 = Async Dial
1 = Sync Dial
2 = Sync Leased (Answer)
3 = UNIX Dial
4 = Sync Leased (Originate)
5 = Cellular (Mobile) (Valid only if ETC is installed)
6 = Cellular (PSTN) (Valid only if ETC is installed)
n is one of the following configuration areas:
where:
0 = Active (Saved)
1 = Customer 1
2 = Customer 2
Loading Configuration Areas to Active (Operating)
Use the ATZ n command to load stored configurations from Active (Saved), Customer 1, or
Customer 2 configuration areas to Active (Operating).
Type: ATZ n
n is one of the following:
where:
0 = Active (Saved)
1 = Customer 1
2 = Customer 2
3 = Active (Saved) + Reset
11