Table of Contents
Advertisement
Tracking Error Adjustment
®
Semiconductor Lead Layouts
(1) Place a test record (YFSC-16) on the turntable
(3) After completing step (2), cause the tonearm to
and press the START/STOP button for lead-in.
lead in, and then go UP after the tonearm base
2SB731
2SB941
MC931
(2) Adjust with the adjustment screw so that the
RENE?
2SD414-R
2SD1266
tonearm base does not move just after the tone-
(4) Check the count at this time, and then check
2SD809
arm goes down.
that the difference
in count
when
the tonearm
:
goes down again is within 5 counts.
letter side
2SD1388
2SC2603F
DTA114ES
DTA124ES
tonearm base
DTA124XS
7
DTC124ES
ce
"a
DTC114ES
Vf
IF,
CZ
tracking error adjustment screw
— Adjustment Direction —
For (2) when the arm base moves, turn to the
step (4)
step (2)
right.
/| \
E
Cc
For
(4) when
the
difference
in count
is too
large, turn to the left.
HW-300B
2SB1014
fet
TC9142P
LM6402G-575
Drop Point (30 cm) Adjustment
(1) Place a test record
(YFSC-16)
on the turntable
and press the START/STOP button for lead-in.
(2) Adjust the horizontal position adjustment screw
so that the drop point at this time is within the
10E2
Specification:
9 — 14 counts
cathode
anode
(Top view)
GL-3HD1
/
anode
cathode
M5218L
GL-5EG22
horizontal position adjustment screw
count decreases when turned to the right
long
short
count increases when turned to the left
anode
cathode
Advertisement
Table of Contents
