Remove the power board with cable
Make sure the following FRUs (or CRUs) have been removed.
"Remove the lower case" on page 62
"Remove the battery pack" on page 63
"Remove the CMOS battery" on page 69
"Remove the I/O bracket (right)" on page 70
"Remove the I/O board with cable" on page 71
Step 1.
Peel off the tape carefully.
Figure 69. Peel off the tape
Step 2.
Remove two screws and then remove the power board with cable.
Figure 70. Remove the power board with cable
Screw specifications
M1.6 x L2.7
Number of screws
2
.
Chapter 4
Removing a FRU or CRU
73