Advertisement
Installation Considerations
This section focuses on some considerations for installing your Can-Am
Maverick X3 subwoofer kit. This subwoofer enclosure is designed to
work in conjunction with Rockford's other X3 specific audio kits and
parts.
If you feel unsure about installing this system yourself, have it installed
by a qualified technician.
When drilling holes, make sure what is on the other side. Be sure that
any electrical, fuel lines or any other important components are free
and clear from the area.
~
WARNING
A
CAUTION
A
CAUTION
Before installation, disconnect the battery
negative(-) terminal to prevent damage to
the unit, fire and/or possible injury.
Before beginning any installation, follow
these simple rules:
Be sure to carefully read and understand the
instructions before attempting to install this
wiring kit.
Consult your UTV's service manual for model specific information.
Models may differ from year to year depending on factory options
and aftermarket accessories added.
This subwoofer kit is specifically designed to work with Rockford
Fosgate's RM series of subwoofers.
With the addition of an amplifier or source unit, be sure that your
current charging system is in proper working order.
,
Visit
rockfordfosgate.com
for more comprehensive product
information
.
Visit our
VouTube
channel for comprehensive installation videos
demonstrating complete installation guides and install tips.
NEED HELP WITH YOUR INSTALLATION?
-@
VISIT OUR CHANNEL FOR A COMPLETE
►
YOUTUBE
INSTALLATIONVIDEOANDOTHERTIPS
WWW.YOUTUBE.COM/USER/ROCKFORDFOSGATE
Applicable Models:
Can-Am Maverick X3 (2 & 4 seat models)
This front subwoofer enclosure is designed to work with Rockford
Fosgate's RFX3-K4 / RFX3-K8 amplifier wiring kits. The enclosure is
installed in both 2-seat and 4-seat models on the driver side of the
vehicle underneath the front seat.
Step 1.
Remove the desired front seat/seats ..
Step 2.
Remove the panel below the shifter to give you access to route
the subwoofer enclosure harness.
NOTE: Routing harness will be done after enclosure is mounted.
Step 3.
Load the subwoofer into the enclosure using the supplied
screws that came with the
woofer.
The subwoofer protective
grille will be installed.
NOTE: Be sure to maintain proper polarity and impedance rating for
the amplifier being used for this installation
.
When using a RM110D2B
subwoofer, be sure use the supplied Red wire to wire the subwoofer in
series to achieve a 4 ohm load.
Installation
Step 4.
Place the subwoofer enclosure into the vehicle.
Step 5.
Secure the enclosure with supplied
hardware.
Step 6.
Connect the subwoofer harness to enclosure and route the
wire harness through the center console and up the dash.
NOTE: Be sure to use supplied plastic wire ties to secure harness.
Step 7.
Connect to amplifier
harness.
Step 8.
Power up the system and verify all functions. Once done, the
vehicle can be reassembled in reverse
order.
3
Advertisement
