Craftsman 247.985390 Operator's Manual page 10

.
Makesureaii cables are routedto the left of the chutecontrol rod.
Line up the hole in the chutecontrol rod with the arrowon the
inputshaftand insert the rod intothe inputshaft belowjoystickon
handlepanel.See Figure7.
NOTE:Thechute controlrod will fit snugglyintothe inputshaft.
Supportthe rear of thedash panelwith one handwhileinsertingthe
rod with yourotherhandto ensurethe rod is insertedall the way into
the input shaft.
8. Nowpushthe chutecontrol rod back towardsthe handlepanel
untilthe hole in the rodlines up with the hole in the chute control
inputclosestto the chutecontrolhead. Insertthe cotterpin. See
Figure8.
NOTE:The secondholeis usedto achievefurther engagement o f
chute controlrod into the inputshaftif requiredand can be usedlater
for adjustmentif the chutedoes not fully rotate.Referto the Service&
Maintenance sectionfor ChuteControlRodadjustments.
9. Finishsecuringchute controlheadto chutesupportbracketwith
wing nut, and clevispin and bow-tiecotterpin removed earlier.Do
notovertighten.See Figure9.
/
.J
Figure8
x
\
\
y..................
Figure7
Figure9
10