Mitsubishi S120 User Manual page 19

5 SIGNAL
AUTO .................. Use to select AUTO, USER 1 or USER 2.
HORIZ. POSITION .... Use to adjust the horizontal position of the image.
VERT. POSITION ..... Use to adjust the vertical position of the image.
FINE SYNC. ....... Use to synchronize the projector with PC input signals so
that the image is not blurred.
TRACKING ......... Use to avoid image noise such as wide stripes.
RGB INPUT ........ The unit adjusts itself automatically when connected to
either DVD players with a component video output
terminal (Y, C
signal output capabilities. In cases where the unit is
connected to equipment that include an RGB output
terminal and which output HDTV signals, adjust the unit
to RGB mode.
HOLD .................. Adjusts the image which upper side is awry.
6 SIGNAL - USER (Normally, there is no need for adjustments.)
CLAMP POSITION/
CLAMP WIDTH ......... If you use a PC video card or something similar, the
brighter colors of the projected image may become blurred.
In this case, adjust CLAMP POSITION or CLAMP
WIDTH.
HORIZ. PIXELS .... Use to adjust the width of the image. The image size grows
wider as the number increases. (Adjust to the horizontal
pixels of inputting signal for normal setting.)
VERT. LINES ..... Use to adjust the height of the image. The image size
grows higher as the number increases. (Adjust to the
vertical lines of inputting signal for normal setting.)
PLL ...................... Use to adjust the image which upper side is awry. Select AUTO for normal setting.
VERT. SYNC. ..... Use to adjust the image when its motion does not run naturally. Select AUTO for normal
setting.
SQUEEZE ........... Set to ON when displaying DVD discs which are recorded as the squeezed image (in right
and left direction).
, C or Y, P , P ) or equipment with HDTV
B R B R
19