Zenith VCP352 Operating Manual page 8

Hook-Up
(continued)
Step 4: Connect VCP to the TV
Refer to the following illustration to properly connect the VCP to your TV.
1. Connect one end of the round coaxial
cable supplied with your VCP to the RF
OUT terminal of the VCP.
Figure 3: Connecting the VCP to Your TV
(Back of TV)
AUDIO
IN
VIDEO
VHF/UHF/CATV
IN
Note: An alterative to using the RF cable is to
connect the Audio/Video Out jacks on the VCP
to the corresponding jacks on your TV (if
present). However, these cables are optional
accessories that are not supplied with the VCP
but should be available from your Zenith video
product retailer.
Step 5: Supply Power to the VCP
1. Plug the AC adapter power cord into an
operating 120V AC outlet and the other
end into the DC input on the back of
the VCP, or
2. Using the adapter cord, plug one end of
the cord into a 12 volt negative ground
DC source (such as the cigarette lighter
socket of a car) and the other end into
the DC input on the back of the VCP.
2. Connect the other end of the cable to
the RF IN (or ANT IN)terminal on your
TV.
CHANNEL
3
4
ANT.IN
VHF/UHF
RF.OUT
DC I N 1 2V
-8-
VIDEO
OUT
AUDIO