Electrolux LCC83443 User Manual page 9

How to install your Electrolux
Extractor Hob 80 cm
Filter housing assembly
Before the first use make sure to insert the
filter inside the housing with the black sides
facing inwards and the silver sides facing
outwards. Refer to "Cleaning the hood filter".
Once the filter housing is assembled, put it
inside the hood system and place the grid on
the hood.
3.5 Connection cable
• The hob is supplied with a connection
cable.
• To replace the damaged mains cable, use
the cable type H05BB-F or H03V2V2-F
which withstands a temperature of 90 °C
or higher.
220-240 V~
N
N
L1
L2
220 - 240 V~
5x1,5 mm²
Green - yellow
N Blue and blue
L1 Black
L2 Brown
www.youtube.com/electrolux
www.youtube.com/aeg
N
L1
L2
Two-phase connection: 400 V2N~
5x1,5 mm² or 4x2,5 mm²
N
L1
L2
• The single wire must have a diameter of
minimum 1,5 mm².
• Speak to your local Service Centre. The
connection cable may only be replaced by
a qualified electrician.
WARNING!
All electrical connections must be made
by a qualified electrician.
CAUTION!
Connections via contact plugs are
forbidden.
CAUTION!
Do not drill or solder the wire ends. It is
forbidden.
CAUTION!
Do not connect the cable without cable
end sleeve.
400V2N~
Green - yellow
Blue and blue
Black
Brown
220-240 V~
N
L
One-phase connection: 220
- 240 V~
5x1,5 mm² or 3x4 mm²
Green - yellow
N Blue and blue
L Black and brown
ENGLISH 9