Electrolux LCC83443 User Manual page 23

Problem
The control panel becomes hot to
the touch.
There is no sound when you
touch the panel sensor fields.
The indicator above the symbol
comes on.
The control bar blinks.
The hood does not start or turns
off. The indicators above the
hood control symbols might also
blink.
The hood fan does not work
properly when the hood functions
are activated.
The steam produced during
cooking is not sufficiently absor‐
bed by the hood.
and a number come on.
Possible cause
The cookware is too large or you put
it too close to the control panel.
The sounds are deactivated.
Child Safety Device or Lock oper‐
ates.
There is no cookware on the zone or
the zone is not fully covered.
The cookware is unsuitable.
The diameter of the bottom of the
cookware is too small for the zone.
The fan may turn off by itself in cer‐
tain conditions, e.g. when the room
is not properly ventilated.
The ambient temperature surround‐
ing the hood is too high.
There is insufficient air circulation in‐
side and around the hood.
The lids on the cookware are not
properly placed.
The hood filter is oversaturated.
There is an error in the hob.
Remedy
Put large cookware on the rear zones,
if possible.
Activate the sounds. Refer to "Daily
use".
Refer to "Child Safety Device" and
"Lock".
Put cookware on the zone so that it
fully covers the cooking zone.
Use cookware suitable for induction
hobs. Refer to "Hints and tips".
Use cookware with correct dimen‐
sions. Refer to "Technical data".
Open the window. You may need to in‐
stall the window switch. Refer to "As‐
sembly". If the window switch is al‐
ready present, make sure it was cor‐
rectly installed. Refer to the installation
booklet.
Press any symbol. The hood operates
again.
Deactivate the hob and unplug it from
the main power supply. Wait at least
10 seconds, then plug it in again.
Other suggestions:
Try to cool down the temperature of
the surrounding area. Take out the
hood filter and remove the residual
moisture from the inside of the hood.
Refer to "Care and cleaning". Leave
the hood system to dry for one day,
then activate the hood again.
If your cookware does not have vented
lids, make sure to tilt the lids so that
the released steam is directed towards
the hood.
Refer to "Hints and Tips" for informa‐
tion on the special Steam Vented Lids
recommended to be used with the inte‐
grated hood.
Regenerate the hood filter and reset
the notification. Refer to "Care and
cleaning".
Deactivate the hob and activate it
again after 30 seconds. If
on again, disconnect the hob from the
electrical supply. After 30 seconds,
connect the hob again. If the problem
continues, speak to an Authorised
Service Centre.
ENGLISH
comes
23