Vibration Testing; Cleaning; Safety Inspection; Disposal - ebm-papst R6D630-FA07-01 Operating Instructions Manual

Hide thumbs

Table of Contents

R6D630-FA07-01

In the event of further malfunctions, contact ebm-papst.

5.1 Vibration testing

Checking of fan for mechanical vibration based on ISO 14694.

Recommendation: Every 6 months. Max. vibration severity is 3.5 mm/

s, measured at the motor fastening diameter on the motor support plate in

the direction of the motor axis of rotation and perpendicular to this.

Fig. 2: Example illustrating vibration measurement. The arrangement of

the sensors depends on the device concerned and the installation

situation.

5.2 Cleaning

To ensure a long service life, check the fans regularly for proper

operation and soiling. The frequency of checking is to be adapted

accordingly depending on the degree of soiling.

DANGER

Risk of injury from rotating fan.

→ Only clean when not in motion. Interrupt the power supply,

secure against renewed switch-on. Secure against start-up,

prevent air flow.

; Dirt deposits on the motor housing can cause overheating of the motor.

; Soiling of the impeller can cause vibration that will shorten the service

life of the fan.

; Severe vibration can destroy the fan.

; In such cases, switch off the fan immediately and clean it.

; The preferred method of cleaning is dry cleaning, e.g. using

compressed air.

; Do not use aggressive cleaning agents!

NOTE

Damage to the device during cleaning

Malfunction possible

→ Do not clean the device using a water jet or high-pressure

cleaner.

→ Do not use any acid, alkali or solvent-basedcleaning

agents.

→ Do not use any pointed or sharp-edged objects for cleaning

; Completely remove any cleaning agents used.

Item no. 16818-5-9970 · ENU · Change 210990 · Approved 2020-10-08 · Page 11 / 12

ebm-papst Mulfingen GmbH & Co. KG · Bachmühle 2 · D-74673 Mulfingen · Phone +49 (0) 7938 81-0 · Fax +49 (0) 7938 81-110 · info1@de.ebmpapst.com · www.ebmpapst.com

Operating instructions

; If severe corrosion is visible on load-bearing or rotating parts, switch

off the device immediately and replace it.

; Repair of load-bearing or rotating parts is not permitted!

; Operate the fan for 2 hours at maximum speed so that any water that

has ingressed can evaporate.

; If cleaning does not eliminate vibrations, the fan may need to be

rebalanced. To have it rebalanced, contact ebm-papst.

; The fan is equipped with maintenance-free ball bearings. The lifetime

lubrication of the ball bearings is designed for a service life of 40,000

hours.

; If bearing replacement is necessary after that period, contact ebm-

papst.

; Adapt the maintenance intervals to the actual level of dust exposure.

5.3 Safety inspection

What to check

Contact

protection

cover for

intactness or

damage

Device for

damage to

blades and

housing

Fastening the

cables

Fastening the

protective earth

terminal

Insulation of

cables for

damage

Impeller for

wear/deposits/

corrosion and

damage

Condensation

drainage holes

for clogging,

where necessary

Abnormal

bearing noise

Vibration test

5.4 Disposal

For ebm-papst, environmental protection and resource preservation are

top priority corporate goals.

ebm-papst operates an environmental management system which is

certified in accordance with ISO 14001 and rigorously implemented

around the world on the basis of German standards.

Right from the development stage, ecological design, technical safety

and health protection are fixed criteria.

The following section contains recommendations for ecological disposal

of the product and its components.

How to check

How often