Advertisement
4. CONTENTS
5. OPERATION
BEARING REMOVAL (fig.2 & fig.3)
5.1.
5.1.1.
Prepare the vehicle for the wheel bearing to be removed.
Note: When GEN2 wheel bearings are removed, the retaining ring will sustain damage.
DO NOT re-fit a bearing once it has been removed.
5.1.2.
Fit the black hub clamp (5,6) behind the hub flange with the recessed side facing the hub carrier.
Secure the hub clamp (5,6) with the hub clamp screws (12).
5.1.3.
Fit the hub guide pins (10) into the thrust plate (11) so that the hub guide pins (10) align with the holes
in the hub flange. Place the hub guide pins (10) though the holes in the hub flange so that they sit against
the hub clamp (5,6) (fig.3).
5.1.4.
Lubricate the force screw (2).
5.1.5.
Fit the force screw (2) through the thrust plate (11) and through the bearing and hub carrier.
5.1.6.
Place the black bearing plate (7,8) over the force screw (2) so that it sits on the outer race of the
bearing.
5.1.7.
Screw the sleeved nut (9) over the force screw (2) so that it sits against the bearing plate (7,8).
5.1.8.
Use a socket on the force screw (2) and a spanner on the sleeved nut (9) (fig.3). Draw the bearing from the hub carrier.
fig.2
© Jack Sealey Limited
Item
1
2
3
4
5
6
7
8
9
10
11
12
13
fig.1
fig.3
Original Language Version
Model No
Description
Case
Force screw
Hub clamp stud end silver
Hub clamp silver
Hub clamp stud end black
Hub clamp black
Bearing plate small
Bearing plate large
Sleeved nut
Hub guide pin
Thrust plate
Socket cap bolt
Hex key
VS7029.V3 Issue:1 07/08/23
VS7029.V3
Qty
Part Numbers
1
VS7029-V3-01
VS7029-V3-02
1
VS7029-V3-03
1
VS7029-V3-04
1
VS7029-V3-05
1
VS7029-V3-06
1
VS7029-V3-07
1
VS7029-V3-08
1
VS7029-V3-09
1
VS7029-V3-10
1
VS7029-V3-11
1
VS7029-V3-12
1
VS7029-V3-13
Applications
Audi
A1 (2010 - on)
A2 (00-05)
Seat
Cordoba (03-09)
Ibiza (02-12)
Skoda
Fabia (00-12)
Roomster (06-12)
VW
Fox (05-10)
Polo (02-12)
Advertisement
