Cable Service - Zenith HealthView H20D50DT Installation And Operating Manual, Warranty

Cable Service (CATV) Hook Up
Connect cable service to the HealthView TV
1
Locate the Antenna/Cable jack on the back
of the HealthView TV.
2
Connect the cable service wire that runs
from the wall, according to one of the dia-
grams to the right.
3
Remove the back of the optional remote and
put in two AA batteries.
4
Plug in the TV. Do not plug it into a
switched outlet. The HealthView TV is
designed to operate on standard current,
120-volt 60 Hertz AC. Do not attempt to
operate it on DC power.
5
Go to page 11 to Auto Program the TV.
If you're using a cable box, leave the TV on channel
3 or 4 and use the cable box to change channels.
If you're using a cable box, Auto Program might
only find the channel the cable service is on (usual-
ly channel 3 or 4).
206-3491-O
back of
remote
Cable TV
Wall Jack
RF Coaxial Wire
(75ohm)
Cable TV
Wall Jack
Cable Box
In
output
Out
switch 3 4
RF Coaxial Wire
(75ohm)
TV Back
TV
SPKR
ANTENNA
CABLE
PILLOW
Video Speaker
SPKR
In Out
M.P.I. PILLOW SPEAKER
Audio
In
TV Back Panel
(Expanded View)
TV Back
TV
SPKR
ANTENNA
CABLE
PILLOW
Video Speaker
SPKR
In Out
M.P.I.
PILLOW SPEAKER
Audio
In
TV Back Panel
(Expanded View)
P A G E 7