Zenith HealthView H20D50DT Installation And Operating Manual, Warranty page 9

Cable Service (CATV) with VCR Hook Up
Connect Cable service and a VCR to the
HealthView TV
1
Locate the Antenna/Cable in jack on
the back of the VCR.
2
Connect the wire that runs from the
cable service wall jack, according to
one of the diagrams to the right.
3
Remove the back of the optional remote
and put in two AA batteries.
4
Plug in the TV. Do not plug it into a
switched outlet. The HealthView TV is
designed to operate on standard cur-
rent, 120-volt 60 Hertz AC. Do not
attempt to operate it on DC power.
5
Go to page 11 to Auto Program the TV.
Leave the VCR and the television tuned to channel three
or four and use the cable box to change channels.
206-3491-O
back of
remote
Cable TV
Wall Jack
Out
In
output
switch 3 4
Cable Box
ANTENNA
CABLE
M.P.I.
TV Back Panel
(Expanded View)
Cable TV
Wall Jack
VCR Back
VCR Back AV Panel
output
In
switch
Video
Out
TV
SPKR
PILLOW
Video Speaker
SPKR
In Out
PILLOW SPEAKER
Audio
In
P A G E 9
3 4
Audio