Cable Service - Zenith HealthView H2050DT Installation And Operating Manual, Warranty

Hook Up The Cable (CATV) to the TV
Connect cable service to the HealthView
Locate the Antenna/Cable jack on the back of
1
the HealthView TV.
Connect the cable that runs from the wall
2
directly to this jack, according to the diagram
to the right.
Remove the back of the remote and put in two
3
AA batteries.
Plug in the TV. Do not plug it into a switched
4
outlet. Your HealthView
operate on household current, 120-volt 60
Hertz AC. Do not attempt to operate it on DC
Current.
5 Go to page 11 to Auto Program the
HealthView TV.
If you're using a cable box, leave the TV on
channel 3 or 4 and use the cable box to change
channels.
If you're using a cable box, Auto Program might
only find the channel the cable service is on
(usually channel 3 or 4).
206-3491-O
TV.
back of
remote
TV is designed to
Cable TV
wall jack
RF coaxial wire (75 ohm)
Cable TV
wall jack
Cable box
In
output
Out
switch
3 4
RF coaxial wire (75ohm)
TV back
ANTENNA
CABLE
TV
M.P.I.
PILLOW SPEAKER SPKR
PILLOW
SPKR
TV back
ANTENNA
CABLE
M.P.I. TV
PILLOW SPEAKER SPKR
PILLOW
SPKR
P A G E 7