Cable Service - Zenith H19F34DT Installation And Operating Manual, Warranty

Cable Service Hook Up (CATV)
Connect cable service to the Concierge TV
1
Locate the Antenna/Cable jack on the back of the
Concierge TV.
2
Connect the cable service wire that runs from the wall,
according to one of the diagrams to the right.
3
Remove the back of the remote and put in two AA batter-
ies.
4
Plug in the TV. The Concierge TV is designed to operate
on standard current, 120-volt 60 Hertz AC. Do not
attempt to operate it on DC power.
120 V AC
60 Hz
5
Go to page 11 to Auto Program the Concierge TV.
If you're using a cable box, leave the TV tuned to channel 3
or 4 and use the cable box to change channels.
If you're using a cable box, Auto Program might only find the
channel your cable service is on (usually channel 3 or 4).
206-3745
Back of
Remote
TV Back
Cable TV
Wall Jack
Super
RF Coaxial Wire Port
(75 ohm)
TV Back Panel
(Expanded View)
Cable TV
Wall Jack
Cable Box
In
Output
Out
Switch 3 4
Super
RF Coaxial Wire
Port
(75ohm)
ANTENNA
CABLE
SPEAKER
OUT
VIDEO
AUDIO
IN
IN
M.P.I.
TV Back
ANTENNA
CABLE
SPEAKER
OUT
VIDEO
AUDIO
IN
IN
M.P.I.
TV Back Connections Panel
(Expanded View)
P A G E 7