Download Print this page

Troubleshooting - homed JLN-S0 A Series User Manual

Piston compressor nebulizer

Advertisement

Shenzhen Homed Medical Device Co.,Ltd
1
10
100
For transmitters rated at a maximum output power not listed above, the recommended separation distance d
in meters (m) can be estimated using the equation applicable to the frequency of the transmitter, where P is
the maximum output power rating of the transmitter in watts (W) according to the transmitter manufacturer.
NOTE 1: At 80 MHz and 800 MHz, the separation distance for the higher frequency range applies.
NOTE 2: These guidelines may not apply in all situations. Electromagnetic propagation is affected by
absorption and reflection from structures, objects and people.

10 Troubleshooting

Problem
Excessive noise with the device
The device doer not operate
Excessive water drops attached
inside the tubing wall
11 Warranty and Validity
Validity of Main Unit: Two years
Validity of Nebulizer parts: single use
The legal provisions in this respect apply. The warranty is limited to detective material and workmanship.
Batteries and cable are not covered by the warranty, damage through misuse or modification is not covered. The
warranty is only valid if the product has neither been opened nor subjected to violence or willful damage and it is
return with the original receipt. Contact your dealer if you have any complaints. For further information contact
the customers service (TeL: +86 0755 29821671/29821673/29821675, E-mail: sales-oe@systems.citizen.co.jp).
In the event of warranty claims being deemed to be justified, the customer concerned will be supplied with a
replacement product. The customer is only entitled to receive a comparable replacement product.
Caution: Instructions for a correct disposal of the product
Disposal requirement: Comply with WEEE directive, it must be disposed of in accordance with the locally
applicable regulations, not with domestic waste.
Shenzhen Homed Medical Device Co,.Ltd
1.2
3.8
12
Probable cause
No filter
Power off
Not clean the cup last time
Tube bends
Filter blocks
No medication liquid
Inhalation top or baffle does not
screw well
Too much medication liquid loaded
1.2
3.8
12
Add the appropriate medication
Remove some liquid by tool, until
the liquid line down to the 8ml scale
File No.: JLN-S0XA-CE-14
2.3
7.3
23
Solution
Reload a filter
Power on
Clean the cup
Unbend the tube
Replace a new filter
liquid into the cup
Screw it well
mark.
Page 9 of 10

Advertisement

loading

Related Products for homed JLN-S0 A Series

This manual is also suitable for:

Jln-s01aJln-s02aJln-s03aJln-s04 aJln-s05aJln-s06a