Table of Contents
Advertisement
3.
Run the machine until the engine runs out of fuel.
4.
Prime the engine and start it again.
5.
Allow the engine to run until it shuts off.
When you can no longer start the engine, it is
sufficiently dry.
6.
Allow the engine to cool.
7.
Remove the key.
8.
Clean the machine thoroughly.
9.
Touch up chipped surfaces with paint available
from an Authorized Service Dealer. Sand
affected areas before painting, and use a rust
preventative to prevent the metal parts from
rusting.
10.
Tighten all loose screws, bolts, and locknuts.
Repair or replace any damaged parts.
11.
Cover the machine and store it in a clean, dry
place out of the reach of children.
Removing the Machine
from Storage
Perform the annual maintenance procedures as given
in the Recommended Maintenance Schedule; refer to
Maintenance (page
19).
26
Advertisement
Table of Contents
