Antenna With Vcr; Hook Up Antenna And Vcr To The Tv - Zenith H1934Y Installation And Operating Manual, Warranty

Hook Up Antenna and VCR to the TV

Connect your off-air antenna and VCR to the Concierge TV.
Locate the Antenna/Cable jack on the back of the VCR.
1
Connect the cable that runs from the antenna directly to
2
this jack, according to the diagram to the right.
3
Remove the back of the remote and put in two AA batter-
ies.
4
Plug in the TV. Do not plug it into a switched outlet. The
Concierge TV is designed to operate on standard current,
120-volt 60 Hertz AC. Do not attempt to operate it on DC
Current.
5
Go to page 11 to Auto Program the Concierge TV.
Remember, when screwing RF cables onto jacks, clockwise
tightens, and counterclockwise loosens.
No A/V cables are included with the Zenith Concierge TV.
Model H2539Y does not have the MPI card.
P A G E 8
back of
remote
Antenna
Flat wire
(300 ohm)
TV back
ANTENNA
CABLE
Super
Port
VIDEO SPEAKER
M.P.I. IN OUT
AUDIO
IN
TV back panel
(expanded view)
TV back
ANTENNA
CABLE
Super
Port
VIDEO SPEAKER
IN OUT
M.P.I.
AUDIO
IN
TV back panel
(expanded view)
VCR back
VCR back AV panel
output
In
switch
3 4
Out
Video
Audio
300/75 ohm
Adapter
RF coaxial wire
(75 ohm)
not included
with TV
A/V cables
not included
with TV
Antenna
VCR back
RF coaxial wire VCR back AV panel
(75 ohm)
output
In
switch
3 4
Out
Video Audio
RF coaxial wire
(75 ohm)
not included
with TV
A/V cables
not included
with TV
206-3490-O