Table of Contents
Advertisement
Programming the Remote
The remote control of your HD receiver is a multi-
brand or universal remote control that can be
programmed to operate most remote-controllable
devices of other manufacturers.
Note that the remote control may not control all
models of other brands.
Test your remote control.
1
To find out whether your remote control can
operate the component without program-
ming, turn on the component such as the
VCR and press the corresponding mode but-
ton (VCR) on the remote control while
pointing at the component. Test the POWER
and CH +/- buttons to see if the component
responds properly. If not, the remote
requires programming to operate the device.
Turn on the component to be programmed.
2
Then press the corresponding mode button
on the remote control.
Press the POWER button and the MUTE but-
3
ton simultaneously. Then the remote control
is ready to program the code for the corre-
sponding component.
There are two ways to find the right code for
4
the component.
A. If you press the CH +/- buttons repeat-
edly, the code will change one at a time.
Press the POWER button after each code
change. If the right code is found, the
device will turn off.
B. Enter a code number using the number
buttons on the remote. The right code num-
bers for the corresponding component can
be found on the following pages.
Again, if the code is correct, the device will
turn off.
Press the EXIT button to store the program.
5
Test the remote control functions to see if
6
the component responds properly. If not,
repeat from step 2.
206-03816
vcr cable dvd sat
tv
mode
light
2
source
antenna
video
comp1
comp2
1
2
4
4
5
7
8
0
3
mute
vol
swap pipch- pipch+ pip
flashbk surf freeze
menu
record stop
pause rew
play
power
3
front
rgb
3
6
9
enter
ratio
4
ch
exit
5
skip
ff
P A G E 4 5
Advertisement
Table of Contents
