Table of Contents
Advertisement
TRAXXAS STABILITY MANAGEMENT (TSM)
Traxxas Stability Management or
TSM allows you to experience all
the speed and acceleration that was
engineered into your Traxxas model
by helping you to maintain control of
the boat. TSM helps provide straight ahead full-throttle acceleration,
even across rough water. TSM makes corrections for you and allows
accurate maneuvers, without intruding on your fun or creating
unexpected side effects.
The Multi-Function knob on
the TQi transmitter has been
programmed to control TSM. The
recommended (default) setting for
TSM is to rotate the knob to the
12:00 position (the zero mark on
the dial).
Turn the knob clockwise to
increase assistance; turn the knob
counterclockwise to decrease
assistance. Turn the knob
Decrease
counterclockwise to its stop
assistance
to turn TSM completely off.
Note: TSM is deactivated
TSM off
automatically when driving
in reverse.
When driving the boat in calm water, decrease the TSM setting to
allow the vehicle to feel more "loose" for full-throttle turns, high
speed gliding, and so on. In rougher water, increase TSM to maximize
acceleration and control.
Drive with TSM on and off to test how it is making your control of the
boat easier and more precise. For more information, visit Traxxas.com/
tsm.
Note: TSM must be completely turned off while adjusting steering trim.
Recommended setting
Increase
assistance
TQ
RADIO & BRUSHLESS POWER SYSTEM
i
Setting Up the Antenna
The receiver antenna has been set
up and installed from the factory.
The antenna is secured by a 3x4mm
set screw. To remove the antenna
tube, simply remove the set screw
with the included 1.5mm wrench.
When reinstalling the antenna, first
slide the antenna wire into bottom
of antenna tube until white tip of
antenna is at top of tube under the
black cap. Next insert the antenna
tube into the mount while making
sure that antenna wire is in slot in
the antenna mount, then install the
set screw next to the antenna tube.
Use the supplied 1.5mm wrench
to tighten the screw just until the
antenna tube is securely in place.
Do not over tighten. Do not bend
or kink the antenna wire! Do not
shorten the antenna tube.
To prevent loss of radio range do
not kink or cut the black wire, do
not bend or cut the metal tip, and
do not bend or cut the white wire
at the end of the metal tip.
No
No
No
Correct
SPARTAN • 17
Advertisement
Table of Contents
