Table of Contents
Advertisement
Programming the Remote
Set up your remote to operate other IR controlled brand name devices:
VCRs, Cable Boxes, TVs, Satellite Receivers, DVD Players, Audio CD Players, Audio Tape Decks,
Audio Tuners and Amplifiers etc. See listing on pages 42/43
1
Turn on the device you want to program.
2
On the chart on page 42/43, find the type of device you're
programming, and then find the brand name. Make a note of
the three-number code, you'll need it soon.
3
Press and hold PRG. It's recessed so it doesn't get pushed
accidentally. Use a small, blunt object. When the indicator
light turns on, you can release PRG.
4
Push the key name with the type of device you're program-
ming (VCR, CABLE, AUX, TV).
5
Using the NUMBER keypad, enter the three-number code you
found on page 42/43.
6
Press ENTER to save the code. (The indicator light will flash 3
times, then turn off to indicate the code is valid.)
7
Point the remote at the device and push POWER. It should
turn off. If not, try the other codes listed and continue from
step three.
Notes
• To reset remote to factory settings, enter 9-1-1, in Step 5.
• After programming, be sure to press the mode key first to
operate the device you have just programmed.
Programming your Zenith remote may allow you to use one remote
to work up to 7 different devices.
Not all devices will work with your Zenith remote control.
Mini glossary
PROGRAMMING
Procedure to set up remote to operate other equipment.
PRG
Programming mode key.
DEVICE
Infra-red remote controllable electronic accessory equipment.
P A G E 3 8
Indicator Light
3
PRG
CABLE
VCR
AUX
SURF
FLASHBK
CHANNEL
VOLUME
CHANNEL
5
1
2
4
5
7
8
0
ENTER
MENU
RECORD
PAUSE
TIMER
PLAY
REWIND
STOP
7
POWER
4
TV
MUTE
VOLUME
3
6
9
6
QUIT
TV/VCR
SOURCE
FFWD
206-3483
Advertisement
Table of Contents
