Table of Contents
Advertisement
INSTALLATION
1. Attach Mounting Blocks on Window Frame (See Fig.1)
1) Remove adhesive from mounting block and place mounting block on
window frame.
2) Press down firmly on the mounting block to secure in place.
3) Then, remove adhesive from the other mounting block and place
mounting block on window frame.
4) Press down firmly on the mounting block to secure in place.
5) The mounting block are now ready to support the Hybrid Air Condi-
tioner.
2. Slide Hybrid Air Conditioner Over Window Sill
1) Open window completely
2) Lift the Hybrid Air Conditioner on either side of the unit and bring it up to the window.
3) Insert the unit into the window until the center of the Hybrid Air Conditioner is over the window sill.
4) Slowly lower the Hybrid Air Conditioner over the window sill so that the unit straddles the wall.
5) Paying close attention to your fingers, completely lower the Hybrid Air Conditioner onto the window sill.
6) Center Hybrid Air Conditioner in the window so that there are equal gaps on either side of the unit.
*Use the adjustable supports to secure the Hybrid AC against
the outside wall. (See Fig.2)
*Use the bubble level to make sure the unit is balanced
when secure on the window sill. When balanced, the bubble should
between the two black lines. (See Fig.3)
3. Attach Window Slider Foam Sealer (See Fig.4 and 5)
1) Measure the distance between the air conditioner and the window sash.
2) Cut to length by using a utility knife
Fig. 4
Fig. 5
Fig.1
Fig.2
Fig.3
Advertisement
Table of Contents
