Setting The On Timer; Setting The Sleep Timer; Auto Off - Zenith C27F33 Installation And Operating Manual, Warranty

Available Features

Setting the On Timer

On Timer automatically turns the TV on at the preset time and tunes to
the specified channel.
1. Press the menu button and then use
menu shown to the right.
G
2. Use the and then D /
3. Repeat OFF TIMER steps 3 to 6.
4. Press the button to select
E
select the desired channel.
5. Press the button to select
E
to adjust the volume level.
6. Press the menu button to remove menu.
Notes
• If you don't press any button within 2 hours after turning on the TV
with the ON TIMER function, the TV will automatically switch back
to standby mode.
• TV must be in standby mode for the On Timer to work.

Setting the Sleep Timer

You don't have to remember to switch the TV to standby mode before
you go to sleep. The Sleep Timer automatically turns the TV off after
the preset sleep time expires.
Use the Sleep button to select the desired sleep time.
Each time you press this button, preset sleep time settings are
displayed one by one as shown below. The Sleep Timer begins to
count down from the number of minutes selected.
---
Notes
• After a few seconds, the desired sleep time setting will disappear
and the TV turn-off function will operate automatically.
• To view the remaining sleep time, press the sleep button once
and the remaining sleep time will be displayed.
• To cancel the sleep timer, select the
button.
• "SLEEP 1" will be displayed one minute before the TV is due to
turn off.

Auto Off

If there is no input signal, the TV is switched to standby mode
automatically in 10 minutes.
1. Press the menu button and then use
menu shown to the right.
G
2. Press the and then use
F G
3. Use the / button to select
4. Press the menu button to remove menu.
D / button to select the
E
button to select
E
and then use the
and then use the
--- setting with sleep
D / button to select the
E
D / button to select
E
or .
12
.
F G
/ button to
F / G button
.
:
: