Prg; Cable Vcr; Surf Flashbk; Channel - Zenith C27A24T Operating Manual & Warranty

Programming the Remote

Program your remote to work with a vast range of A/ V devices.
The device you want to program
1
should be ON.
On the chart in this manual, find the
2
type of device you're programming and
then find the brand name. Make a
note of the three-digit code—you'll
need it soon.
Press and hold the PRG key. It's
3
recessed so it doesn't get pushed
accidentally. When indicator light
behind the PRG button turns on, you
can release the button.
Push the button with the name of the
4
device you're programming (VCR,
CABLE, TV).
Using the number pad, enter the
5
three digit code found on the chart in
the Reference section.
Press ENTER to save the code The
6
indicator light will flash three times
and turn off if the code was
accepted.
Aim the remote at the device and
7
push the POWER button. It should
turn off. If not, try the other codes
listed and continue from step three.
Note: After programming, to operate
the device you have just programmed,
press the proper Mode button first.
Programming your Zenith remote
will allow you to use one remote
to work up to 7 different devices!
Not all devices will work with your
Zenith remote control.
206-3588
3
Indicator Light
4
5

POWER

PRG

CABLE VCR AUX TV
SURF
FLASHBK

MUTE

CHANNEL

VOLUME

VOLUME
CHANNEL
1 2 3
4 5 6
7 8 9
0

ENTER

QUIT

MENU

TV/VCR
RECORD PAUSE TIMER

SOURCE

PLAY

REWIND

FFWD

STOP

7
6
P A G E 3 1