Zenith C19A02D Operating Manual & Warranty page 8

Hook Up Your Antenna and VCR
Connect an antenna and VCR to your Entertainment Machine.
Locate the Antenna/Cable jack on
1
the back of your Entertainment
Machine.
Connect the cable that runs from
2
the wall directly to this jack,
according to the diagram to the
right.
Remove the back of the remote
3
and put in two AA batteries.
Plug in your Entertainment
4
Machine. Do not plug it into a
switched outlet. Your
Entertainment Machine is
designed to operate on house-
hold current, 120-volt 60 Hertz
AC do not attempt to operate it
on DC Current.
Go to page 10 to Auto Program
5
your Entertainment Machine.
If you have a 75 ohm RF cable,
then you don't need any adapters!
Remember, when screwing RF
cables onto jacks, clockwise tight-
ens, and counterclockwise loosens.
P A G E 8
back of
remote
Flat wire antenna with VCR to
Entertainment Machine
Antenna
Flat wire
(300 ohm)
300/75 ohm
Adapter
TV back
RF coaxial wire (75 ohm)
not included with TV
TV back panel
(expanded view)
Antenna
Cable
Antenna with VCR to
Entertainment Machine.
Antenna
RF coaxial wire (75 ohm)
not included with TV
TV back
RF coaxial wire (75 ohm)
not included with TV
TV back panel
(expanded view)
Antenna
Cable
VCR back
VCR back AV panel
In Output
3 4
switch
Out
Video Audio
VCR back
VCR back AV panel
Output
In
3 4
switch
Out
Video Audio
2 0 6 - 3 5 8 6