To Change The Lamp; When The Appliance Is Not In Use - Electrolux EUC31300 Instruction Book

Defrosting can be accelerated by
placing bowls with hot water (not
boiling) inside the freezer.
Loosen the drainage channel from its
resting position and push in according
to the illustration and place it in the
bottom freezer drawer where water
can collect.
Carefully scrape off the ice when it
starts to thaw. Use a wood or plastic
scraper. Do not use sharp objects as
these may damage the interior.
When all the ice has melted, clean and
wipe the cabinet dry, then put the
drainage channel back in place.
Switch on the cabinet and replace the
frozen foodstuff.
Never use a hair drier or other heating
appliances to speed up defrosting.
Excessive heat may damage the
plastic interior, and humidity could
enter the electric appliance making it
live.

To change the lamp

The light is switched on automatically
when the door is opened. Before
replacing the light bulb, disconnect the
power plug from the outlet.
Disassemble the lamp by using a
screwdriver in the recess on the lamp
insert. To prise it out of its location.
Assemble a new lamp by guiding it
into a centred position and press until
it snaps into place.
Use a halogen bulb of the same type,
maximum rating of 20 W.

When the appliance is not in use

Disconnect the appliance from
electricity supply.
Empty all foods and clean the
appliance, leaving the doors ajar to
prevent unpleasant smells.
If the cabinet is to be kept on, ask
somebody to check it once in a while
to prevent the food inside from spoiling
in case of a power failure.
14