Zenith A27B43 Operating Manual page 38

P A G E 3 8 M B R Z - T R A K O P E R AT I O N
Programming the MBR Z-Trak
Operate
your
equipment
with the
1
MBR Z-Trak.
2
3
4
5
P R O G R A M M I N G T H E M B R Z - T R A K T R AC K BA L L R E M OT E
Select the equipment you want to
program, then turn to pages 39-40 to
find the programming code appropriate
for the type and brand of equipment.
Make sure the equipment is turned on.
Point the MBR Z-Trak remote at the piece
you're programming, and press MUTE and
FLSHBK at the same time. Hold until one
of the mode indicator LEDs lights.
Use the MODE Right/Left button
to select the appropriate mode for
your equipment.
With the Number Keypad, enter the
three digit code you found in step 1 and
press ENTER. If the code is accepted, the
mode indicator LED will blink three
times. If it is not accepted, the LED will
not blink.
Note: The TV, and VCR, modes will only
accept codes for those types of products.
The CABLE, AUX 1, and AUX 2 modes will
accept codes for any kind of product.
Push the POWER button to turn off the
equipment. If nothing happens, repeat
the process from step 1, and try the next
code number.
To get out of Programming before you
enter a code, just press the QUIT button.
Indicator lights
2
rew
5
cable
mode 3
surf
2
5
4
8
0
pip
stop
f. fwd
play
3357-O