Yamaha EC-03 2012 Owner's Manual page 23

TIP
When the vehicle is in the riding mode,
the beeper sounds. The beeper stops
when either brake lever is squeezed or
the vehicle starts moving.
Control buttons
Button 1 "POWER"
Button 2 "SET"
Button 3 "SELECT"
The following operations and settings
are made using these buttons.

Changing from the standby mode
to the riding mode

Switching between the odometer
and the tripmeter

Resetting the tripmeter

Registering or changing the secu-
rity number

Locking and unlocking the security
lock
Speedometer
The speedometer shows the riding
speed.
Tripmeter "Trip"
The tripmeter shows the distance trav-
INSTRUMENT AND CONTROL FUNCTIONS
eled since it was last set to zero. To re-
set the tripmeter, push and hold button
3 "SELECT" for a few seconds until
"0.0" is displayed.
Odometer "Odo"
Push button 3 "SELECT" for at least
one second to switch the display to the
odometer.
The odometer shows the total distance
traveled. Use the odometer as a refer-
ence for the intervals between perform-
ing periodic maintenance.
Push button 3 for at least one second to
switch the display to the tripmeter.
Temperature warning display
"HEAT"/"COOL"
The EC-03 is equipped with a tempera-
ture protection function to protect the
battery and control unit.
If a problem is detected, the tripmeter/
odometer display is canceled and
"COOL" or "HEAT" flash.

When the temperature of the bat-
tery or control unit exceeds a spec-
ified temperature, "HEAT" flashes.

When the temperature of the bat-
tery falls below a specified temper-
4-4
ature, "COOL" flashes.
TIP

When the temperature of the bat-
tery exceeds a specified tempera-
ture, "HEAT" flashes and the
driving power is reduced to limit
the electric output from the battery,
but this is normal.

When the temperature of the bat-
tery falls below a specified temper-
ature, "COOL" flashes and the
driving power is reduced to limit
the electric output from the battery,
but this is normal.

If the vehicle is ridden for an ex-
tended period in high tempera-
tures, "HEAT" may flash and the
riding speed may be reduced.

If the vehicle is ridden after it has
been left in a hot place or under di-
rect sunlight, "HEAT" may flash
and the riding speed may be re-
duced.

If the vehicle is ridden after it has
been left in an excessively cold
place (less than 0 C), "COOL"
may flash and the riding speed
may be reduced.
2
3
4
5
6
7
8
9