AEG COMPETENCE 30380 B Operating Instructions Manual page 7

INSTALLATION INSTRUCTIONS
NOTE: HOUSE CIRCUIT
Earth leakage and continuity tests must be carried
out before the cooker is connected to the mains
supply and re-checked after fitting.
THINGS YOU NEED TO KNOW
WARNINGS:
This cooker must be installed by a qualified
electrician/competent person. Safety may be
impaired if installation is not carried out in
accordance with these instructions.
. This cooker must be earthed.
Do not remove the screws from the earth tab
extending from the oven mains terminal block
(Fig. 6).
- Before connecting the cooker make sure that
the voltage of your electricity supply is the
same as that indicated on the rating plate. The
rating plate can be seen by opening the oven
door and looking below the oven door seal.
Do not alter the electrical circuitry of this
cooker.
THINGS TO NOTE
+ This cooker is designed to be fitted in cabinets
of the recommended dimensions as shown
(Fig. 2).
If your cabinet interior dimension is between
565-570.mm the oven may still be fitted.
However, a minor modification to the cabinet
will be required.
The dimensions given provide adequate air
circulation around the unit within the cabinet,
ensuring compliance with BS EN60-335.
Enquiries regarding the installation of the
cooker point if required should be made to
your Regional Electricity Company to ensure
compliance with their regulations.
The cooker socket switch should be outside
the cabinet but within 2m of the cooker to
make it accessible to switch off the cooker in
case of an emergency.
To protect the hands wear gloves when lifting
the oven into its housing.
GETTING THINGS READY
CHOICE OF ELECTRICAL CONNECTION
a)
c)
There are three possible ways to connect your
cooker. In each case the cooker should be
operated using at least 6mm? twin core and
earth PVC insulated multicore cable. Please
choose from the most appropriate after reading
the different methods:-
By connecting the cooker to a cooker point
(having a double pole isolating switch with at
least 3mm contact separation in all poles and
neutral) and protected with a fuse or miniature
circuit breaker at your mains fuse box.
Subject to Regional Electricity Company |
regulations If you wish to connect the
oven and hob to the power supply you
may use one of the following two
methods:-
By connecting the cooker together with a hob
directly to a cooker point(s). Having a double
pole isolating switch with at least 3mm contact
separation in all poles and neutral.
If you wish to connect an oven and a hob to a
cooker point you can by connecting the oven
and hob separately to the cooker point. Oven
and hob units should be separately connected
to a control panel. See Fig. 1.
Control Panel