AEG COMPETENCE 30380 B Operating Instructions Manual page 12

FITTING INTO THE CABINET
IMPORTANT: Ensure that the oven is switched
off at the wall before any further work is carried
out.
a)
b)
c)
d)
e)
f)
9)
h)
12
Using a tape measure establish the internal
width of the cabinet. Refer to page 8 if greater
than 565mm.
Position the cooker in front of the cabinet. See
Fig. 7.
Take out ali oven furniture before installation to
reduce the weight you need to lift. The oven
door should be taped up to keep it closed
whiist lifting.
To place the cooker into the cabinetry follow
the procedure below:-
N.B. Two people will be required to carry out
the lifting procedure.
Each person shouid squat either side of the
cooker.
Tilt the cooker so that your hands can support
the underside of the cooker.
Keeping your back straight, raise the appliance
to the cabinet by straightening at the knees.
Rest the rear underside of the cooker on the
cabinet floor while your hands support the
tront.
The cooker can be pushed fully into the
cabinet. Take care to avoid fouling the mains
lead.
Ensure the cooker is central in the cabinet and
level.
When the cooker is fully housed, screw the
stability screws (supplied with the cooker) into
the side of the cabinet taking care not to distort
the side trims (see Fig. 8). It is advisable to
turn each screw alternately to avoid damaging
the trims.
Switch on the cooker then refer to the
operating instructions in the following pages.
Fig. 7
Mains
Cable
Pack Base
Fixing Points
for
Stability Screws