Table of Contents
Advertisement
gS
TT
DU
aE
E
I
I
TT
ET
I
TTT
FACSIMILE (cont.)
PROBLEM
E The other party complains that
documents are being received with
distorted letters.
@ The unit has been set the Auto
Receiving mode, but a document
cannot be received automatically.
@ The START indicator flashes for about
40 seconds after the unit receives a call
automatically, but nothing is recorded.
E The unit does not operate properly.
E When I receive or copy a document
whose background is very dark or
containing photographs, the unit may
produce a high tone.
E Problems receiving international
facsimiles.
M I cannot transmit the document by
using the ONE-TOUCH transmission
and a long beep is heard.
CAUSE AND REMEDY
elf you have call waiting service, it may have
been activated by another telephone call. Re-
connect the unit to a line that does not have call
waiting service.
eSomeone may have used a telephone
connected in parallel with the unit.
Avoid connecting the same line for the unit and
other telephone.
Confirm whether you have recorded the following
OGM-"To send a FAX, push the asterisk button."
or not. See page 9.
The caller hung up during or immediately after the
playing of the OGM. This may occur if the
disconnect signal is not transmitted from the
Central Office, and your unit is in normal condition.
Turn the POWER switch off, then turn it on again.
This is quite normal.
eRefer to the INSTALLATION MANUAL, page 13
and 14.
eShorten OGM to 10 seconds or less.
eG II receiving speed may need to be set to
4800 bps.
eCED frequency may need to be set to 1100 Hz.
Someone is using the external telephone.
ANSWERING MACHINE
BB When the CALL indicator
flashes slowly;
A power failure has occurred, confirm whether
the voice messages are recorded on the tape
or not.
Advertisement
Table of Contents
