Motor Cover - Designers Fountain ASTREA Installation Instructions Manual

INSTALLATION (CONTINUED)
3
ASSEMBLE THE MOTOR AND ROD
 Loosen the motor set screws (L)
on the top of the motor (M).
 Pull the wires from the motor (M)
through the center of the rod (F).
 Twist the rod (F) onto the motor
(M) until it is tight, and then
unscrew the rod (F) slightly until
the holes in the rod (F) and the
holes on the motor (M) align.
 Insert the clevis pin (G) through
the holes the motor (M) and rod
(F), and then secure it with the
cotter pin (H).
 Tighten the motor set screws (L).
4
ASSEMBLE THE TOP
 Thread the wires through the
motor cover (K), the canopy cover
(J), the canopy (I), and hanger
ball (E).
 Push the motor cover (K) down
the rod (F) to cover the screws on
the motor (M).
 Insert the straight pin (C) into the
top of the rod (F), and push the
hanger ball (E) up so it locks with
the straight pin (C).
 Tighten the ball set screw (D) on
the hanger ball (E).
G
L
C
D
I
J
K
M
8
F
H
M
E
F