Dokki.eu CMT-1 Quick Reference Manual

Quick Reference Guide CMT-1
Legal Notices
This manual and any examples contained herein are provided "as is" and are subject to change without notice. JNC makes no warranty
of any kind with regard to this manual, including, but not limited to, the implied warranties of merchantability, non-infringement and
fitness for a particular purpose. JNC shall not be liable for any errors or for incidental or consequential damages in connection with the
furnishing, performance, or use of this manual or the examples contained herein.
Reproduction, adaptation or translation of this manual is prohibited without prior written permission of JNC Service B.V.
CAUTION: This Quick Reference Guide may be revised or withdrawn at any time without prior notice.
This document provides basic instructions for setting up your DOKKi.eu CMT-1 docking station.
The CMT-1 will fit Opticon scanner models OPN-2001, OPN-2002, OPN-2005 and OPN-2006.
Before inserting an OPN-2002 be sure to remove the rubber USB cover (if any).
As new models are released continuously, make sure to check our website for the list of
compatible models first if your models isn't listed here!
Other models (for example the OPN-2003, OPN-2004) won't fit.
Trying to insert unlisted models will result in damage to the CMT-1 and other scanner model!

BOX CONTENTS

The box contains the CMT-1 docking station. Promotional items aren't listed here.

DRIVER INSTALLATION

The DOKKi.eu CMT-1 itself does not need a separate driver. The only driver that needs to be installed on your PC is the appropriate
driver for your scanner model that you wish to use on the CMT-1. If not already done so, please follow the instructions for driver
installation in the corresponding manual that belongs to your scanner model.

PHYSICAL CONNECTION

Connecting your CMT-1 docking station to your host computer is done with the original USB host
cable that was supplied with your OPN scanner.
1. Connect the USB A (male side) of the host cable to a free USB port on your PC;
2. Connect the mini-USB (mini B5 male side) connector on your USB host cable to back of your
CMT-1 docking station.
You are now ready to use your CMT-1 docking station!

DOCKING YOUR SCANNER

Press firmly but never use excessive force when pressing down as this might damage the connectors!
Check for obstructions on both connectors and retry connection.
DOKKi.eu is a trademark of JNC Service B.V. ('JNC'). Copyright JNC Service B.V. All rights reserved.
Hold the scanner between your thumb and index finger on the OPN's body where USB
connector is situated in the side (thus, not in the middle but more to the left side). Simply
connect your OPN scanner to the docking station by gently placing the OPN over the CMT
to align the connectors. When aligned press the scanner down to secure the connection.
DOKKi
CMT-1 compatible models
CMT-1_QRG-003 / July 2014
.eu