Led Instructions - Eureka NEW400 Series Owner's Manual

Machine Status
Standard mode
High mode
Self-cleaning
Dirty water tank is full
Fault alarm
Charging
(adapter connected)
Charging finished
(adapter connected)
Battery level alert
Note:
1. The machine must not be tilted so much that the brush is lifted off the ground, as this will cause dirty
water to be sucked in by the vacuum motor and then sprayed out and back onto the ground.
2. Do not suck up large debris to prevent brush roll and suction port from clogging as this may cause a
weakening of the suction power or stop the machine from working properly.
3. Before handling or transporting the machine, make sure that both the clean water tank and the dirty
water tank are emptied of water, otherwise the machine will be damaged by water ingress.
12
Eureka Customer Service HELPLINE 1-800-282-2886

LED Instructions

ON/OFF button LED
Display according to remaining battery level
Display according to remaining battery level
/
Purple LED flashes
Red LED flashes
Below 10% battery level: Red LED always on
10%-40% battery level: Purple LED always on
Above 40% battery level: Blue LED always on
Blue LED will be on and go out after 5mins
Above 40% battery level: Blue LED always on
10%-40% battery level: Purple LED always on
Below 10% battery level: Red LED always on
High/Low Self-cleaning
button LED
Blue LED always ON
Blue LED flashing
Blue LED
/
always ON
/
/
/
/
/
button LED