Table of Contents
Advertisement
KEYPtAD FUNCTIONS.
1. LED Readout (R OOM HUMIDITY):
The LED
window displa ys the following information
independently;
A. Internal {Room En vironment) Relativ e
Humidity Conditions.
B. Set Operating Relativ e Humidity Value.
NOTE: The LED readout is programmed todef
aultto
displa y the ambient (room en vironment) relativ e
humidity conditions.
To view the Set Operating Relativ e Humidity Value, (2.)
press the "up" or "down" button (once) and the set RH
operating value will flash f or approximately 5 seconds In
the LED windo w, then re vert bac k to displa y the inter nal
(room en vironment) RHv aiue.
2. ON/OFF Button
: Each time this b utton is pressed
the unit turns On (adjacent indicator light illuminates) or
Off (adjacent indicator light is not illuminated).
3. CONTINUOUS
: Used for Continuous Dehumidifier
Operation, (unit will run non-stop) NO TE; Humidity
values (settings) cannot be programmed in this mode
.
The adjacent (green) indicator light illuminates to signify
the 'continuous' mode is currently in operation.
4. HUMIDITY UP:
This b utton allows y ou to increase
the relative humidity setting. Each time this b utton is
pressed the RH v aiue setting is increased incrementally
by 5%. (ranging from 35% ~ 80%)
5.. HUMIDITY DO WN: This button allows you to
decrease the relativ e humidity setting. Each time this
button is pressed the RH v aiue setting is decreased
incrementally by 5%. (ranging from 80%-35%)
6. HIGH F AN: The adjacent (green) indicator light
illuminates when HIGH FAN is selected.
7. LOW FAN: The adjacent (green) indicator light
illuminates when LOW FAN is selected
8. WATER FULL INDICATOR: This (red) light
illuminates under the f ollowing conditions;
A. When the inter nai water tank is not proper !y
installed inside the cabinet.
B. When the inter nal water tank Is full.
The
Water tank must be emptied and replaced bac
k
in the cabinet bef ore nor mal operating
conditions can resume .
7
Advertisement
Table of Contents
