Table of Contents
Advertisement
4. Check the oil level window (20) prior to start-up
and regularly during operation. Refill oil when the
oil level is lower than "MIN" marking
(Fig. 3c).
5. Wipe up spilled lubricant with a soft cloth and refit the oil tank cap (21).
NOTE: Always dispose of lubricant, used oil and objects contaminated with
them in accordance with local regulations.
Checking
NOTE: Perform the following test before operating your product.
This product is equipped with an automatic oiling system. The oiling system
automatically delivers the proper amount of oil to the bar and chain.
Checking the lubrication requires starting the product. Before checking, the
product must be fully assembled and all instructions must have been read.
1. Make sure the guide bar (4) and the saw chain (3)
are in place when you check the oil delivery.
2. Start the product; keep it running at no load and
check if the chain oil is delivered as shown in the
figure (Fig. 3d).
3. If required have the chain oil flow adjusted by an authorised service centre or similar qualified person.
Connection to the power supply (for UK only)
WARNING! Always use a residual current supply (RCD) protected supply. If an
extension cord is used, make sure the extension cord is specifically designed for
outdoor use and not lighter than H07RN-F, 2 x 1.5 mm² and max. 75 m.
1. Make sure the on/off switch (13) is in its off position.
2. Correct the power plug to a suitable power source.
3. Now your product is ready for use.
3663602627913_MNL_IN_V02.indd 19
3663602627913_MNL_IN_V02.indd 19
21
19
20
MIN
Fig. 3c
Fig. 3d
3/3/2023 2:42 PM
3/3/2023 2:42 PM
Advertisement
Table of Contents
